If you have Express Tools installed you can easily check what certain system variables do and what their options are from the System Variable Editor. In the Sysvar monitor dialog click on the “RESET ALL” button.ĭoing so will replace the current value of each system variable with the preferred value for all the listed system variables defined in the Sysvar monitor settings.I’m sure you can think of many more ways your system variables change, but how do we deal with them now that System Variable Monitor is in place? Simple – reset them. Or perhaps you canceled that routine mid-stream before it could set them back?.You ran an old LISP routine and your system variables just changed without your permission.You just opened a drawing from a vendor and got notification several variables have changed.There are always scenarios where things were changed out of the gate: With the SYSMON variable set to “2” I’ll also get balloon notifications. Use SYSVARMONITOR command to view changes. I’m going to manually change the FILEDIA system variable to “0” – as we talked about in the introduction being a common problem.Īs you can see I’m now getting a warning on the command line and status bar.ġ of the monitored system variables has changed from the preferred value. This option when checked displays a balloon notification when a system variable does not match the Preferred value.Also see the SYSMON system variable for additional control.This option when checked tracks the changes of the listed system variables and display notifications when current values do not match the preferred value.Notify When These System Variables Change.The following options are available for maintaining the system variables in your list: ![]() Sysvar monitoring and notification options. Join the Autodesk Virtual Academycommunity and never stop learning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |